@VectorStyler https://youtu.be/76XU1spklUk?feature=shared Here are the issues and suggestions: 1. These tools can't display parameters in real time. When using the straight line tool, it's often just a temporary measuring tool, and I need to undo the operation after checking the angle. The offset tool also can't update in real time, while the drawn straight lines have this function. 2. After using the offset tool, the stroke shifts, but the "skeleton" (not sure about the correct term, temporarily called skeleton) stays in place. In scenarios like the example, when duplicating a graphic in place and offsetting the upper path, it's mostly impossible to select the lower graphic—instead, the upper "skeleton" gets selected. Hope the offset tool can make the skeleton and stroke shift as a whole for easier selection of other graphics. 3. The rounded endpoints show abnormal transitions when using the width tool. For regular flat endpoints, even if the value in the width tool panel is 0, they aren't sharp corners when zoomed in, while AI handles these two points normally. Hope these aspects can be optimized. Thank you!

@Li-Xiao 这个操作真的很新奇，好像管理员都没有想到。这个功能我是基本用不上了。工作中没有太适合的场景。现在依然觉得论坛里你玩VS最溜。

Well, sort of. That's what it does now. But, this is sort of like having a combination salt shaker and surgeon's scalpel. One is relatively benign (translation) and the other very intrusive and potentially dangerous (changing Bezier control points). The amount of time it takes to recover from a mistake with either varies hugely. I convert a line to a Bezier curve or vice versa probably 3 or 4 times a year. I move graphic elements hundreds of time per session. What I was requesting was to separate these so that you have the Bezier conversion tool be an "expert" feature and translation be something a novice could use safely. Your video doesn't show the current behavior that, a straight line segment will be converted to a Bezier curve just by dragging. That's a real expert feature. Normally, I just draw Bezier curves when I want them and don't try to convert between normal line segments and Beziers.

@EricP said in How to crop a vector design ?: is it a ratio between height and width of the shape ? Yes, something like this. I often end up ungrouping them for the sake of the selection but there may be a better way. I'v Double click the group and that will isolate for selection.